Putting In Bullnose Corners

Putting In Bullnose Corners

If your house was constructed sometime after the early 2000s, you will have seen it is lacking square corners. Instead, most of your corners are rounded, or you've got bullnose baseboard corners. This rounded drywall corner provides properties a recent look with out an excessive amount of trouble when drywalling.

But when you're putting in the baseboard round bullnose corners, things change into more complicated. Now not are you lining as much as forty five-degree corners (miters); installing bullnose nook baseboard trim requires more precision.

Our bullnose corner tool, the ¾’’ Bullnose Corner Gauge helps take the guesswork out of those extra steps. The flaps can help you draw a line on both the wall and the baseboard piece you are cutting to ensure an ideal fit each time. Our guide for putting in these professional-trying baseboards for rounded corners with the ¾’’ Bullnose Trim Gauge, is below.

STEP 1: PREP YOUR BASEBOARD PIECES
Your baseboard items needs to be at the least slightly longer than your wall sections. Measure your small pieces to the size of the nook they may end on, however then lower with the extra board on the end so that you can make your mark. Do this for each sides.

STEP 2: MAKE YOUR MARKS (MEASURE YOUR BASEBOARD)
With your trim prepped, take each bit and align it for marking. Mark both sides of the wall and each piece. Your wall line will now serve as a guide when fitting. You may double-check your mark with a tape measure, but if in case you have aligned everything square, that ought to be accurate.

STEP 3: MAKE YOUR CUTS
With your items in hand, use your marks to make 22.5-degree cuts being careful not to reduce the mark (go away your mark seen after you chop). You’ll need these angled in to fit together with your center-piece.

STEP four: CUT YOUR CENTER PIECE
A key distinction between the standard 45-degree cuts and the rounded trim corners is the middle- piece. The piece will slot in between your two cut items to convey the nook together. These must be 5/8’’ with two outward-facing 22.5-degree cuts.

STEP 5: FITTING
Together with your items in place, go back to your corner and dry-fit. Align the lower in your size items to the mark on the wall to ensure they still match correctly.